Selecting the “View Report” button on the NFC Scan pop up window, will close the previous pop up and reveal the full NFC Scan Report.
The data from the NFC scan is extracted and presented to the you (the operator).
The following fields will be presented in the NFC Scan Report:
Model - The model (manufacturer and type) from the scanned water meter
Meter No - The meter code from the scanned water meter
AMR No - The AMR Number from the scanned water meter (RF Address or Radio ID)
Meter Reading (kL) - Last recorded accumulated flow volume, scaled to Kilolitres. Note that this is current only from the last time that the EEPROM was written to by the meter which may be up to 24 hours previously)
Reading Timestamp - The current timestamp when EEPROM was last written to, effectively giving you the timestamp for the previous reading field. If the timestamp from this record is more than [system constant] minutes old compared to the current device timestamp, this will be highlighted to the user with a red exclamation mark icon (see example to the right). If not, a green check icon will be shown.
Firmware Version - The firmware revision number stated by the device.
Register ID - The register ID stated by the device.
.
Closing this control will return the you to the main advice form below, and then re-open the NFC scan control.
